Cce Repair Tips

Search: cce
Results: 4816

Make	Model	Symptom	Problem	Solution	By
CCE	TV - 2118 USP / AV	When you increase the volume the sound becomes shaking and the image shakes	Capacitor da power supply c 831 de 1000uf /25v	Replace	Mauro Mascarenha Tel. (88) 981422821
CCE	TL660	TV with stand by LED on but it wouldn't turn on	After changing the 1000mf capacitors on the power supply, the TV turned on but the screen lamps kept blinking. Solution: Change the 100mf 25 volt capacitor c28, after changing the TV, it returned to normal		Eletromad
CCE	HPS-21AVP (HPS-2118) H-2197A	Does not turn on c805 stays charged	Bad pwm observes the fr804 if it is open	Replace ci pwm under the board and fr 804	Rogério TV
CCE	LN39G	Stays on standby and doesn't turn on	Button board	After testing all the boards and replacing the 2, the TV still didn't turn on, I saw that tsound was a broken wire in the controls and someone had already soldered it and it didn't solve it, this is the second time that this board had a defect, this display works on LG Smart 39 So as it was my own TV I decided to mount the screen on the LG	william joner
CCE	STILE D32 MIP123	Doesn't start	Fat resistor ci smd	Changing the main power supply fat, plus 4 smd resistors in parallel, they are 3 1r resistors and a 2r2 plus a 470r smd resistor and the 6pin smd ci, i had to remove it from another board, you can't even see the code from him.	Jas plaza
CCE	STILE D3201	Turns on and off with sound and image. d21 led flashing	Resolder the terminals of the con1 board next to the d21 led		Medeiros Eletrônica - MG
CCE	C420	LED stuck in orange or red	It crashed out of nowsound or damn... rewrite eeprom or replace the ec4 capacitor	Ec4-- 470μF 16v https://www.mediafire.com/file/frz28egata02k0p/eeprom_tv_cce_c420_lcd_25q32fv.rar/file	neupsx4
CCE	STILE 40D	No image with osd characters	Replace of the u3 3.3 and u5 1.8v main board.	Arrived for repair if inoperative, cap. 100u to 50v in reg. power supply pwm oscillator! Then it worked perfectly for a minute and the image disappeared, leaving the sound and OSD characters!
CCE	STILE D37	Turns on normally after a minute locks channels locks volume image has green bars	Reg 1.8 vc on the video card close to the power supply connector, just change it, it is only on the card with this voltage		Marco
CCE	LV40G	With time blurred image and turns off	Under the processor heatsink tsound are 2 ceramic capacitors, they are full of glue around them, just clean them and run for hugs
CCE	LED24TV	Red standby and sometimes it turns green	Changing the ci u1 on the main board, I replaced it with an mp2307dn from another cce tv		Assistec
CCE	HPS2171FS	Does not turn on, all voltages are normal, flay oscillates for a few seconds	Changing the 4k7 resistor on the abl line	Rodrigo cofferi	Rodrigo cofferi
CCE	D4201	Stand by red doesn't turn on	Change boots	Replace them all	alexandre felipe
TV CCE	HPS2199	Turning on and off by itself	Change all micro buttons on the keyboard		Douglas santos
CCE	STILE D3201	Backlight keeps turning on and off.	The voltage on top of the pcf capacitor was 290v and should have been approx. 380v.	It was moisture residue under the power supply board. All you had to do was clean it with isopropyl alcohol.	Persio (TVCompany)
CCE	LN 244	Turns on, everything is normal, image and sound are ok, then it suddenly goes out. You turn everything on normally, after 5 minutes it turns off.	Change capacitor ec8. on the main board.		Arock
CCE	STILE D32 LED	Low sound. When you increase the volume, the sound freezes and pops.	1 low impedance speaker	Replace the speaker	Paulão Tchwrma
CCE	LT32G GT-1326EX--D292	LED current reduction	Change r65 from 1k2 to 6k8		Ederlin
CCE	HPS 21AVP HPS	When this TV was plugged in, the LED kept blinking.	The defect was the exhausted c831 capicitor	The TV worked great	Moizaniel santos
CCE	TVP55 000	Broken vertical	Trimoti brξ01 =ξ00 ou 600 r	Replaced sleep....	Jhone eletronica