Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
D4201
|
Stand by red doesn't turn on | Change boots | Replace them all | alexandre felipe |
| TV CCE |
HPS2199
|
Turning on and off by itself | Change all micro buttons on the keyboard | Douglas santos | |
| CCE |
STILE D3201
|
Backlight keeps turning on and off. | The voltage on top of the pcf capacitor was 290v and should have been approx. 380v. | It was moisture residue under the power supply board. All you had to do was clean it with isopropyl alcohol. | Persio (TVCompany) |
| CCE |
LN 244
|
Turns on, everything is normal, image and sound are ok, then it suddenly goes out. You turn everything on normally, after 5 minutes it turns off. | Change capacitor ec8. on the main board. | Arock | |
| CCE |
STILE D32 LED
|
Low sound. When you increase the volume, the sound freezes and pops. | 1 low impedance speaker | Replace the speaker | Paulão Tchwrma |
| CCE |
LT32G
GT-1326EX--D292 |
LED current reduction | Change r65 from 1k2 to 6k8 | Ederlin | |
| CCE |
HPS 21AVP
HPS |
When this TV was plugged in, the LED kept blinking. | The defect was the exhausted c831 capicitor | The TV worked great | Moizaniel santos |
| CCE |
TVP55
000 |
Broken vertical | Trimoti brξ01 =ξ00 ou 600 r | Replaced sleep.... | Jhone eletronica |
| CCE |
TL360
|
Doesn't even turn on the LED | Capacitor principal 47 x 400v | Fernando Pinhais Pr | |
| CCE |
STILE D32
|
Only turns on the LED, without the 12 and 24v voltages | Replace the 4007 on the edge of the power supply board, covered in glue, it feeds the u5 | Rodrigo cofferi | Rodrigo cofferi |
| CCE |
C320
|
Stand by pool, pulsating power supply | Exhausted ec4 capacitor | Replace capacitor ec4, on the couplers side | Luiz Fernando pu2wze |
| CCE |
HPS 2071
|
LED blinks and doesn't turn on | Resistor 5k6 3w... r411 | JR TEC Alagoinhas Ba | |
| CCE |
HPS2198
|
The TV turns on with no image, the LED blinks and does not turn off with the key | Kinescope board | The solution resolders all tube plate components. | Luiz Costa |
| CCE |
TL800
|
It doesn't turn on, it doesn't even light up. 5 volt supply with almost the volts dropping | Capacitor smd c12 placa principal | Pull out and run for a hug | NILSON TVs |
| CCE |
L322
|
Dead power supply | Ic2 and blown resistors | To find the schematic, just search for the k-75l1 board code or the link: https://www.electronica-pt.com/esquema/lcd/fuente-k-75l2-k-75l1-36000/ | Carlos Araujo 82 993677063 |
| CCE |
HPS 2171
|
When cold or discharged, the green LED lights up, press on-off and the TV turns on and in a matter of seconds the green LED goes out and the TV turns off. | The photo coupler, change it, enjoy and also change the tl. the two work together. | Luiz Costa | |
| CCE |
HPS 1471
|
LED blinking and won't turn on | C851 100/25 near the audio connector | FÁBIO | |
| CCE |
HPS1471
|
Blinking LED does not turn on | C851 100/25 near the audio connector | FÁBIO | |
| CCE |
M300S
PLACA CT42 VER. B |
Does not turn on, when connecting 19 volt charger it drops | Smd pc166 capacitor under the board. | Alexandre Oliveira | |
| CCE |
HPS 2197FS
72640.02 |
Power surge | ari Alves celio |