Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
LK42D
|
Sound giving some popcorn (poc - poc - poc) lol image and normal functions | Update firmware - tsound are several software versions on the internet, in my case I work with v2.99 | ||
| CCE |
HPS-2171FS
|
Doesn't start. without +b | C805 sold out | Replace c805 150µ 400v | MARCELO PIRANGA |
| CCE |
D3201
|
Colors with a lot of contrast | I don't know | Erasmo Peixoto | |
| CCE |
TV-1418USP
|
Image closed half down with horizontal lines | Capacitor c425 470uf 16v low capacitance | Eletrosom seemann | |
| CCE |
LN24G
|
Steady orange LED (not flashing) | Orange LED fixed, rewrite the nand, orange LED flashing, probably faulty U12 | HP ELETRONICA | |
| CCE |
HPS-14R
|
Excess width | After seeing all the tensions, everything looks like a gem. | Make replaces suggested by the CCE. replace c410 (410nf/250v) to (1µf/250) and l403 from 140µh to 260µh | Adailson |
| CCE |
D4201
GT 309PX |
Does not tune channels. | Regulator u14 open. 1v voltage does not reach the acg or c to g pin. | O14 - S1117Bh - 2.5 | Gerivaldo |
| CCE |
D4201
GT 309PX |
Does not tune channels. | Regulator u14 open. 1v voltage does not reach the acg or c to g pin. | O14 - S1117Bh - 2.5 | Gerivaldo |
| CCE |
D4201
GT 309PX |
Does not tune channels. | Ressoldar ic u15 (tc90517fc) | Gerivaldo | |
| CCE |
LT28G
|
Reduce the current of the LEDs after changing the buses | Remove r65 from 1k2 and insert r4k7 before the voltage was at 6.22v after the reduction the voltage at each led was at 5.98v | naelson silva gravata pe | |
| CCE |
CW3201 D3201
|
Does not turn on the power supply LED lamps blinks 5 times. | Q9 with leak | Swap the q9 and q8 | eddey alves |
| CCE |
TV 2118USP
|
TV turns on normally, but with reduced vertical at the top and bottom. | Resistor 308 or 309 of 1r and 1r5 changed. | Make the replace God bless. clebson vale - sao joão de pirabas-pa. | Clebson Vale |
| CCE |
TL470
|
Image scrolling.... | Alter pal-n to pal-m | André | |
| CCE |
HPS-1497
|
Only tune in to one channel, just change the characters | Zener diode 702 5v6 volts like leakage | Geronimo | |
| CCE |
D3201
|
Sound failing | Change capacitors ec4 and ec18 470x35v | Joao Bosco Sorocaba | |
| CCE |
LN244
|
It doesn't turn on, sometimes the red LED turns on and the green one turns on, without turning on the TV. | Low output voltage | Replacing the 8-pin regulator u4 mp1484en (just replace) | MULTINFORMÁTICA |
| CCE |
STILE D3201
|
Don't care! it only stays on the red LED | Ci u5 1,8v smd na principal | Eletrônica Cecé. Brumadinho MG | |
| CCE |
LT29G
|
The power comes on soon and then it gets dark | Welding with thermal blower at vcon | Ribas | |
| CCE |
C390
|
TV doesn't turn on only on ST BY. | Defective main board, tsound is no 3v voltage on k-1 and k-0, keyboard connector. | U17 reg 7805 replace and ec4 defective electrolytic capacitor 470μF x16v. | RNSPTEC |
| CCE |
CCE STILE D3201
|
TV when turned on locks sound channels failing +b U5/U3 ok direct swap EC1/8/4 EC2/11/12 | Replace cap ec1/8/4 2/11/12 | Paulo Souza |