Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 2198
|
When plugged into the socket, the volume turns on and works less | Touch on/off key | Domingos da Eletronica | |
| CCE |
HPS 2997 FS
|
Turns on but no video, no blue screen | TRC D902 board diodes, 3, 4 replace without measuring | Domingos da Eletronica | |
| CCE |
HPS-2197 FS
|
Turning on and off or arming the relay and the LED flashes without an image. | C825 [47uf/ 160v] with one of the terminals broken. | If not, I used 33μF/ 160v and it worked without problems. | Altevirlima_Valparaiso Eletrônica_PA |
| CCE |
TV29USP
|
Replace it. This TV came from another workshop and the two power supply fets had been replaced and it was getting too hot, I put the two original fets in and bingo it was ok. | R812 0.22r open | Replace it. This TV came from another workshop and the two power supply fets had been replaced and it was getting too hot, I put the two original fets in and bingo it was ok. | antonio nobrega(patos pb) |
| CCE |
HPS-2185FS
|
Stop | R423 of 4k7 on the line (abl) toast, caused by a defect in the flybak | Swap, the same and also flyback | |
| CCE |
HPS 1407
|
It works normally and after a few minutes it pulls the image to one side of the screen with white clouds. | Defective r414 | To replace | eletronica visão ibirapitanga ba |
| CCE |
HPS2071
|
Does not turn on, power supply +b zero | Capacitor c805 de 150mf/385v seco | Replaced c805, resolved. | PATRICK |
| CCE |
HPSAVP E GENéRICOS
|
Replace c831 of 1000mf/16v for one of 1000/25v | +16v a little low, and c831 swollen, but measuring normal. I had never seen them use insulation of a capacitor equal to the nominal voltage, 16v power supply and 16v capacitor, things from CCE. | Replace c831 of 1000mf/16v for one of 1000/25v | jasvan souza |
| CCE |
TVS-2910 FS
|
Horizon. closed | C-408 e c409 | joelton | |
| CCE |
HPS2071
|
The LED starts flashing with sound and the screen is dark when the screm increases, the screen turns white, horizontal lines appear | Q901,q902,q903,q904,q905,q906. After the replacement, the TV worked normally. | BETO ELETRONICA ACRELANDIA ACRE | |
| CCE |
HPS2981
|
I'm sound | L 101 open | edezio eletronica | |
| CCE |
HPS 1471
|
I'm sound | C634 100mf x 16v | krul | |
| CCE |
TV 2118 USP/AV
|
Traces in the upper part of the tube, doubling the image | Replace resistor fr 301 10 homs | Pedro ironei assitel eletronica | |
| CCE |
TV 29 USP
|
Horizontal shrinking on the left side | C402 substituir | DS eletrônica Afarinio-Pe | |
| CCE |
HPS2971
|
Image full of retrace appearing out of horizontal frequency | R310 150r close to the deflector socket | edezio eletronica | |
| CCE |
HPS2171
|
LED blinking and VCC of IC 801 does not turn on with 10 volts wsound it should have 15 volts | C815 changed | Replace without testing | antonio nobrega(patos pb) |
| CCE |
HPS-2185FS
|
Vertical output. | FERNANDO S | ||
| CCE |
TV2118
|
Does not turn on LED blinks and does not turn on without +b | Ic 802(tl431)colocar original... | vagnernardes | |
| CCE |
HPS2991
|
Vertical closed with line in the center very sharp and deformed up and down, does not open at all typical of deflector | Deflector coil | Replace coil | DEBIQUE |
| CCE |
HPS 1471
|
TV doesn't turn on, just blinks LED and doesn't generate 12v and -12v power supplys | Transistor q802 | Replace transistor directly without measuring | taquari eletronica |