Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS2092
|
I'm on standby | 8 v power supply falling from trt q802 | Zd 501 direct replace | fernado tj maçeio |
| CCE |
HPS1497
|
Does not work, power supply changed and pulsing at 200 volts, exploded capacitor c825 and c829 | 806 diode short-replace | LUIS | |
| CCE |
HPS1497
|
High secondary power supply 200 volts, electrolyte malfunctions. 33mf/160v and 47mf/160v | Cap 806 with leak in the power supply primer - replace it | LUIS-VIDEOSUL | |
| CCE |
HPS3407 FSC
|
Replace the same | C 816 with leak | Replace the same | fbio |
| CCE |
HPS 2171
FSF |
Does not work, standby LED blinks | Tda 9070 processor | Replace, note, you can put the 2071 TV that works | ELETRONICA CB ALVES, CACHORRAO |
| CCE |
HPS1402B
|
TV doesn't turn on and LED blinks on standby | Changing the photo coupler and the tl431 | julio.sertemaq | |
| CCE |
TV-29USP
|
Out of geometry on the lower side vertically stretched | See r401 | Monte Moriah | |
| CCE |
HPS2971
|
TV turns on, has video, no audio, doesn't tune in any channel; changing the memory seemed to solve the problem; that is, it tuned the channels normally; after activating any function, it deprogrammed everything again, appearing to be a memory defect; but it wasn't; and sometimes It even seemed to be the computer because the menu was in English on its own. | Replace the ci (ic 603) tda9855, which is defective and does not release the correct pulses from the sda and scl. | aelson(CUIABANO) | |
| CCE |
HPS-1497
|
It makes a noise on the flay back but it doesn't turn on, turning off the vertical power turns it on | Ci vertical (la78040b) | Barter it | MARCONDES LIMA,Jaicós-PI- Brasil |
| CCE |
HPS 2198AV
|
Channel changing by itself without stopping. volume does not increase on the control and the wrong command button. | Cold solder on resistors r776 and r721. | ||
| CCE |
TVS 2910
|
Without picking up channels without audio | Capacitor c107(470/16) in short located near the variacap was killing the 5v | ||
| CCE |
HPS2198AV
HPS2197FS
|
Pressing power, turns it on and off in 30 seconds, with the LED flashing quickly | Check the known 33mf/160v and 47mf/160v capacitors from the power supply and their respective bc337/25, if everything is ok, check the abl and eht lines that go from the horizontal circuit to the processor. | I found r 405 of 3k9 that goes on the base of open q404, erroneously informing the processor of excessive high voltage. | OLIBIO- ELETRÔNICA ESTUDIER CANOAS RS F.:51-30512464 |
| CCE |
HPS2991FS
|
No audio with hissing and no volume | C613 100mf/16v short on pin 11 of tda9855 | Replace | paulo-maceio/al |
| CCE |
HPS2901
|
Normal league has audio and no image | 100k r910 open on tube plate | I just replaced it and it was 10 | charles cbs |
| CCE |
HPS 21 AVP
|
Turning off | Replace capacitor 829 ( 33uf/160v) | Replace capacitor - 829 | BARRETO CRUZ |
| CCE |
HPS-2991
|
It turns off and on intermittently. image with horizontal shifted to the right. | C409/331kpf with changed value. | edsomvideo | |
| CCE |
HPS2073
|
TV with image and sound, the defect is as if someone had activated the zoom, that is, the width and height are fully expanded | O fly-back tat2012 | Replace it | aelson |
| CCE |
HPS-2908
|
Bad tube-like blurry image | Damaged capacitor | C901-na pci do trc | CENTER SOM ELETRONICA |
| CCE |
VARIOS MODELOS
|
LED flashing intermittently with +b normal | Sound output ic 601 | In my case, I just replaced the sound output | eletronica dimencional |
| CCE |
HPS 2185 FS
|
"breaks" the vertical IC, which could be the la78040, after changing it it's fine for a few days and then "breaks" it again | (-14v) track open. tsound is no point in measuring. This track opens, because when handling the board it rests between the channel selector and the heat sink of the vertical IC. | derli souza |