Cce Repair Tips
Search: cce
Results: 4816
Results: 4816
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS2907 FS
|
Normal power supplys when starting the fly-back groans (sreeeck) giving the impression of being the fly-back, the high voltage is very high, sometimes it works with horizontal reduced by about 1 centimeter on each side. | Capacitor c407 polyester 3n3 2000v with low capacitance. substitute. | WAGGUINHO | |
| CCE |
HPS-2907FS
|
Turns on and off in minutes | R435(smd) aberto | Replace the same, it is located on the abl line | Jarbas (ELETRO-SERV) |
| CCE |
2918USP
|
It had a guitar effect | Q406 leaky transistor | Transistor q406 with leakage, I replaced it and it was great! | DIEGO LIMA DE NOVA TIMBOTEUA PA |
| CCE |
HPS33R
|
Channel change image wobbles looking like power supply | R423 do abl aberto | CARLAOSBC | |
| CCE |
HPS2171FS E SIMILARES
|
Poor audio contact, cuts sound only on channels | C601 e c602 smd | Replace | jasvan souza |
| CCE |
HPS 1481B
|
Turns on, LED lights up, but doesn't oscillate, doesn't generate highs, doesn't work. | Change capacitor 830 and 846 | BARRETO CRUZ | |
| CCE |
HPS - 1481B
|
Warming up q 802 (1897) | Replace - c 846 (ceramic) | BARRETO CRUZ | |
| CCE |
DVD-51K
|
Black and white | Cristal 27.000 | Just replace the crystal and it will be fixed | Eletrônica Áudio e Vídeo |
| CCE |
TL 360
|
Does not turn on or the LED lights up | Zener 801,18 volts | Zezinho Mafra SC. | |
| CCE |
HPS1471
|
Completely stopped and no standby lights up | C 805 | c.r.eletronica | |
| CCE |
HPS-2197
|
Pulling the image on the right side of the screen, with a white stripe. | C417 (331, 2kv) near the flay back | Barter it | Marcondes, jaicós-PI, OHM Eletronica |
| CCE |
HPS1471
|
Black stripe vertically (note horizontal defect) | R414 18k aberto | Replace it and also c 417 | alvaro peralta |
| CCE |
TVS 2910
|
When turned on, the LED turns off but does not send a filament. | Ic301 saida vertical stv8179f. | Just replace it with a new one. | Valmon |
| CCE |
HPS2071A
|
1st when turning on the power supply oscillates, returns to stand bay, 2nd low voltage on +b | 1st change q802 and check fr402 (1r resistor) ''power supply +12'' 2nd change capacitor c825 (47/160v) ''power supply 103'' | Follow the schedule and pay close attention to your diet, ok | jamerson |
| CCE |
TV2118USPAV
|
Won't turn on r414 18k and c417 330 pf burst | Change dz 807 (shorted) | alvaro peralta | |
| CCE |
HPS 1497P
D-1420 |
With rainbow effect image | Saida vertical, ci 301=la78040b/n | I thought about the card socket, but it is not amplifying the sawtooth signal. | HIPERELETRONICA SERVICE (MARCELO) |
| CCE |
HPS 2095
|
Closed vertical and retrace lines at the top of the screen | Solda fria no ci saida vertical - i301 la7837 | Resolve terminals do i301 la7837, replace cap. c302 47μF 50v, cap c306 2.2μF 50v and zener diode d301 12v | Claudinei C - Guarulhos |
| TV CCE |
TV2118USP
|
TV turns on and off oscillating and goes into protection | Capacitors c 417 | I replaced c417 and problem solved | valdir |
| CCE |
HPS2991 FS
|
It doesn't turn on, it just stays on standby | Q804 transistor bc337 da power supply 3v3 | gavioli | |
| CCE |
HPS2185
|
I'm sound | Ic 601 | Replace the same and go out for the hug | eletronica dimencional |