Cce Repair Tips
Search: cce
Results: 4824
Results: 4824
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
TVS 2910
|
When turned on, the LED turns off but does not send a filament. | Ic301 saida vertical stv8179f. | Just replace it with a new one. | Valmon |
| CCE |
HPS2071A
|
1st when turning on the power supply oscillates, returns to stand bay, 2nd low voltage on +b | 1st change q802 and check fr402 (1r resistor) ''power supply +12'' 2nd change capacitor c825 (47/160v) ''power supply 103'' | Follow the schedule and pay close attention to your diet, ok | jamerson |
| CCE |
TV2118USPAV
|
Won't turn on r414 18k and c417 330 pf burst | Change dz 807 (shorted) | alvaro peralta | |
| CCE |
HPS 1497P
D-1420 |
With rainbow effect image | Saida vertical, ci 301=la78040b/n | I thought about the card socket, but it is not amplifying the sawtooth signal. | HIPERELETRONICA SERVICE (MARCELO) |
| CCE |
HPS 2095
|
Closed vertical and retrace lines at the top of the screen | Solda fria no ci saida vertical - i301 la7837 | Resolve terminals do i301 la7837, replace cap. c302 47μF 50v, cap c306 2.2μF 50v and zener diode d301 12v | Claudinei C - Guarulhos |
| TV CCE |
TV2118USP
|
TV turns on and off oscillating and goes into protection | Capacitors c 417 | I replaced c417 and problem solved | valdir |
| CCE |
HPS2991 FS
|
It doesn't turn on, it just stays on standby | Q804 transistor bc337 da power supply 3v3 | gavioli | |
| CCE |
HPS2185
|
I'm sound | Ic 601 | Replace the same and go out for the hug | eletronica dimencional |
| CCE |
TVS2910
|
Image shifted to the right | C402 | edezio eletronica | |
| CCE |
29US
|
Shadow right side 10cm | Change c406 changed | Francisco | |
| CCE |
HPS-2073
|
No signal in rf (av perfect signal) | R108 (12k) on the 33 volt line of the varicap | Replace the same | Jarbas Santos (Eletro-serv) |
| CCE |
HPS2991FSF
|
The TV would turn on and light up the filament, but the tube would not open. | After a lot of brainstorming, I found a defect in the RGB which was in the diodes d903,d904,d902 | After the replacement it was amazing. | chines eletronica solanea PB |
| CCE |
2071
|
TV does not turn on power supply without pulse, LED is off | Q806 remove, the TV works ok. | oficinaeletronica | |
| CCE |
HPS-2071
|
Power supply oscillating (pulsing sometimes it doesn't turn on | Q806 | Replace it (in my case I removed it and the TV worked normally) | antonio nobrega (patos pb) |
| CCE |
HPS2171FS
|
Without image, with normal characters. | Change without testing cap.424 on the abl line | Cap 424 | DEBIQUE |
| CCE |
HPS2046
|
Jagged image in the upper half of the screen, sometimes without sync. | Chap. c405 and/or c404 - leakage and/or loss of capacitance | Replace them | SADER |
| CCE |
HPS-2991FS
|
TV not working LED lights up with a little buzz in the drive | Electrolytic capacitor of 100uf 160v c= 826 close to zero drain of oxidized mf comptos | Replace and analyze | ELETRONICA MEDEIROS |
| CCE |
HPS-2007
|
Does not turn on +b power supply low and stanby led off @@@ | Tl431 | EETRONICA ARNI-L. LEAL- SC | |
| CCE |
HPS21AVP
|
Turns on and then turns off | Capacitor417 (330pfx2kv) | Replace of the same | Julio Cesar ( |
| CCE |
HPS2901
|
Jagged image | Solda fria no d400(smd) | HP ELETRONICA |