Cce Repair Tips

Search: cce
Results: 4820

Make	Model	Symptom	Problem	Solution	By
CCE	D32 LED	Works normal sound, without backlight	Ci bit3251 LED bar power supply controller, pin 5 works with 0 volts and it was at 0.8 volts, the protection turned off the LED bar.	Replace the 10k resistor on pin 5 of the ci with a 3k3 one	EC
CCE	HPS2185	No image, no sound and if you enlarge the screen you get retrace lines	Ic 701, put another blank and that's it	Replace for a blank one	GDP2
CCE	TV HPS 2991	Turn on and off	D410 which is in front of the vertical	Replaced it and it worked again	eletronica soluções tec
CCE	STILE D4201	Does not turn on or turns on with no image or sound (back light on)	100uf ec11 capacitor next to the main 1.8v regulator	Replace capacitor	Julian C Braga (América)
CCE	HPS-2185 ##########	LED on blinks twice and stays on!	Open resistor r411 it is close to the horizontal drive transformer	R411 that powers the horizontal drive	Fernando Nascimento
CCE	HPS 1497	LED blinking, oscillating and cutting out and returns to standby.	Q802 with base open		Eliel Magno
CCE	TV 21US	It doesn't turn on, when it's cold it doesn't turn on, if you heat the plate with hot air it turns on, but when it turns off on the control that leaves it on standby, the LED stays on and then goes off, and it doesn't turn on anymore you have to turn off the main switch and wait a few minutes to turn on, then it turns on. If you turn it off with the main switch, when you turn it on, it turns on.	Power supply defect replace ceramic cap c806, 100nf, 104		DJ PITUKA
CCE	42D	Stand-by LED turns red and green and does not turn on. fails at 3.3 and 5v	Remove u3 and u5, clean and resolder		Luir
CCE	HPS-1407	Very heating capacitor c829 33uf 160v	R411 - 5k6 3w changed giving 5k7, dz805 - c4v7 with escape and swap fly back tat1412a	Replace resolved	Andre
CCE	HPS-1407	Very heating capacitor c829 33uf 160v	R411 - 5k6 3w changed giving 5k7 and changing fly back tat1412a	Resolved	Andre
CCE	HPS-1407	Alloy works normally 1mm image and side reduction of the horizontal and with excess brightness	Abl line dz401 - c4v7 with c419 leak - 1uf 100v bad change without measuring and r406 smd 820r changed giving digital test 841r change	Defect resolved	Andre
CCE	HPS-1407	Vertical dark stripe from top to bottom 5 centimeters 2	Capacitor changed without measuring c425 and c426 - 470uf 16v, r308 - 330r and r308 and r309 - 3r3 changed resistor	Defect resolved	Andre
CCE	HPS-1497P	When turning on, the power supply drops and the tele is stained	C417 de 330pf (331)	Replace	Eletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821
CCE	STILE D4201	Installed 100nf ceramic capacitor and noise disappeared.	Ck 12 altered	Installed 100nf ceramic capacitor and noise disappeared.	Eletrônica JJ
CCE	HPS 1497	Without tuning channels	Change q 101 bc 337 without measuring	Killing varicap 5v voltage	Joel Isidoro
CCE	HPS 2073	Without lighting, the TV turns on but tsound is no lighting on the screen	R822	Replace the r822 to 6r8 and the TV will be working. God be praised!	Sinailson furtado
CCE	HPS 2071	When starting, the LED starts to flash quickly, providing protection.	Q403 and q404 if you remove the jump jc 11 next to the flyback the TV will work again but the problem needs to be resolved	Replace	Eletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821
CCE	LT29G	Blue LED doesn't turn on	Change q10 code a1	You can put another one with code A4 without any problem	eletronica rodrigues
CCE	HPS-21AVP	Tsound is no audio or sound, tsound was a lack of 5 v on pin 16 of the ci 603 and tsound was a short from the aforementioned pin to ground.	C 107 of 470/16 v shorted and r 103 of 33 r open, replaced everything ok		Eurípedes
CCE	LT32G	If, when you replace the card for another, the image turns upside down	Just replace the flash memory u103		Reinaldo